Adjustable Panhard Rod - Rear - Toyota Hilux 130 Series 4Runner

Adjustable Panhard Rod - Rear

Suits

• Toyota Hilux 4Runner 130 Series

Please Note: Check that your current rod doesn't have a brake bias bracket on it. If you need the rod with the bracket you will need the APR006

An absolute necessity on all raised 4WDs is the Adjustable Panhard Rod. Designed to correct axle alignment, the fitment of an Adjustable Panhard rod eliminates potential contact between tyre & body & improves handling issues on vehicles lifted 2" & above.

All Roadsafe Adjustable Panhard Rods are heavy duty, single thread off car adjustable & come complete with bushings & steering damper mounting brackets where applicable.

The majority of Roadsafe Adjustable Panhards now come standard with high flex rubber bushings. This has been a gradual change based on customer demand. Our Roadsafe rubber bushings bring the factory ride feel to the upgraded replacement Adjustable Panhard rods. The high flex Roadsafe rubber bushings offer less noise, vibration & harshness over the polyurethane bushings for panhard applications.

Roadsafe Rubber & Urethane bushings are the same dimensions as the factory original, so all rods are manufactured to factory bush specifications. Bushing replacement if required is easy, just use the factory original or aftermarket.

Design changes over time have seen the implementation of double nuts for extra security, 150mm of adjustment to suit 2-6" lifts & fine 2.0mm pitch thread for finer adjustability.

Roadsafe 4WDs Adjustable Panhard Rods are one of the few on the market that are manufactured from solid bar as standard, as well as boasting an increase in the outside diameter. It's only a matter of time for any vehicle that is used for serious off-road work that the factory panhard will break or bend. This will cause the body of the vehicle to move uncontrolled off centre to the chassis, damaging fuel filler lines, steering linkages & much more!

The 4WD Shed is an Authorised Stockist of Roadsafe 4WD.