Seat Adapter Kit to suit Nissan Patrol GU
The Huracan Fabrication Seat Adaptor Kit to suit Nissan Patrol GU is compatible with any BA, BF, FG or FGX Ford Falcon seat or VE/VF Holden Commodore seat.
The Nissan GU Patrol kit will do both the front seats. Available by request for Single seats only. Also comes with a choice of adding an optional Height Spacer. Please add this spacer if required for the Ford or VE seat adaptor kit.
You will receive custom fabricated and reinforced sliders with 5mm laser cut structural steel adapter brackets that directly interface the Ford or Holden seat (minus its rails) with the GU Patrol floor pan. Any electrics incorporated into the Ford/Holden (VE) rails are removed as part of this mod, so no wiring will be required. The VF seat adapter kits are the exception as they do retain their original electrics, however, they also sit 10-20mm higher than the Falcon or VE Commodore kits.
Our adapter kits come with everything you need to directly bolt in both front seats, right down to the last nut and bolt along with step by step instructions. Minimum seat height under the knees is the same as factory while maximum legroom is extended by a whopping 50 mm! Without the optional spacers the rear of the seat sits approximately 10 mm lower than the factory seats. If you choose to get the spacers you will be provided with shims that go between the floor of the cab and the rear mounting points for the rails raising the rear of the seat back to standard height.
No cutting, drilling, welding or grinding required for the Falcon or Ve Commodore kits. These kits are 100% bolt in. The VF adapter kit does require cutting off the 'feet' on the base of the VF rails so that the original rails can be reused.
The 4WD Shed can supply & fit all our products. Need seats? Give us a call, we can get in seats by request. Not local? We suggest sourcing your seats from Ebay, Gumtree, Facebook or at your local wreckers.
Please note: By purchasing this kit you accept all responsibility for the modification made to your car. We can only endorse this kit for off-road/private use until you have had it approved by your local roads authority or automotive engineer. Seats shown in the ad are for demonstrations purposes only and are not included in the sale.
Do I need to get a mod plate?
Yes. Any seat swap for a vehicle that did not ship with a particular seat from factory will require a mod plate.We advise speaking with your local engineer prior to purchasing to ensure they can sign off on this modification for you. We can assist you with this if you are local to us.
Shipping & Availabilty
Most kits are sent out next business day after ordering. Some kits however, such as tailgate storage mods and 100 series/GU Patrol require significant preparation and can be a couple days or even up to a week before being shipped. If time is critical please contact us for an accurate shipping estimate.
Warranty on my items.
We guarantee the structural integrity of the steel used in our seat adapter kits for the life of the vehicle. For other items, such as tailgate storage and bush armour we provide a 24 months warranty against manufacturing defects EG. defective rivets, welds or laminating etc.
The Ford/Holden seat I purchased came with electric rails. Do I need to wire these in?
No, any electrics in the rails will be removed as a part of this modification so there is no need to wire them in. The only exception is for premium model seats such as some FPV/HSV or Luxury models where lumbar support and back rest angle are electric. If you purchase these seats you will need to wire them up yourself.